Siemens SINAMICS G130 - TM31 Terminals Default Setting

Operation
6.4 Command sources
Inverter chassis units
206 Operating Instructions, 07/2016, A5E00331449A
6.4.2
"TM31 terminals" default setting
Preconditions
● The Power Module, Control Unit and TM31 have been correctly installed.
● The "TM31 terminals" default setting was chosen during commissioning:
•
STARTER (p0700):
"TM31 terminals"
•
AOP30 (p0700):
"2: TM31 terminals"
Command sources
Figure 6-11 Command sources AOP30 <-> TM31 terminals
Priority
The priority of the command sources is shown in the diagram "Command sources AOP30 <-
> TM31 terminals".
Note
LOCAL master control
All of the supplementary setpoints are deactivated for LOCAL master control.