Siemens SINAMICS G130 - CU Terminals Default Setting

Operation
6.4 Command sources
Inverter chassis units
208 Operating Instructions, 07/2016, A5E00331449A
6.4.3
"CU terminals" default setting
Preconditions
● The Power Module and the Control Unit have been correctly installed.
● The "CU terminals" default setting was chosen during commissioning:
•
STARTER (p0700):
"CU terminals"
•
AOP30 (p0700):
"3: CU terminals"
Command sources
Figure 6-13 Command sources AOP30 <-> CU terminals
Priority
The command source priorities are shown in the diagram "Command sources AOP30 <->
CU terminals".
Note
LOCAL master control
All of the supplementary setpoints are deactivated for LOCAL master control.