Siemens SINAMICS G130 - Page 232

Operation
6.6 Communication according to PROFIdrive
Inverter chassis units
232 Operating Instructions, 07/2016, A5E00331449A
Error
value
Meaning
Comment
Additional
info
0x7A Parameter %s [%s]: Write access
only in the commissioning state, data
record base configuration (de-
vice: p0009 = 4).
– –
0x7B Parameter %s [%s]: Write access
only in the commissioning state,
device configuration (de-
vice: p0009 = 1).
– –
0x7C Parameter %s [%s]: Write access
only in the commissioning state,
device download (de-
vice: p0009 = 29).
– –
0x7D Parameter %s [%s]: Write access
only in the commissioning state,
device parameter reset (de-
vice: p0009 = 30).
– –
0x7E Parameter %s [%s]: Write access
only in the commissioning state,
device ready (device: p0009 = 0).
– –
0x7F Parameter %s [%s]: Write access
only in the commissioning state,
device (device: p0009 not equal to 0).
– –
0x81 Parameter %s [%s] must not be writ-
ten during download.
– –
0x82 Transfer of master control is blocked
by BI: p0806.
– –
0x83 Parameter %s [%s]: requested BICO
interconnection not possible.
BICO output does not supply float values, however the
BICO input requires float values.
–
0x84 Parameter %s [%s]: parameter
change inhibited
(refer to p0300, p0400, p0922)
– –
0x85 Parameter %s [%s]: access method
not defined.
– –
0x87 Write job will not be executed. The write job is rejected because know-how protection is
active.
–
0xC8 Below currently valid limit. Modification request for a value that, although within "ab-
solute" limits, is below the currently valid lower limit.
–
0xC9 Above currently valid limit. Modification request for a value that, although within "ab-
solute" limits, is above the currently valid upper limit (e.g.,
specified by the actual converter rating).
–
0xCC Write access not permitted. Write access is not permitted because an access code is
not available.
–