Siemens SINAMICS G130 - Communication Via PROFINET IO

Operation
6.8 Communication via PROFINET IO
Inverter chassis units
250 Operating Instructions, 07/2016, A5E00331449A
6.8
Communication via PROFINET IO
6.8.1
Communication Board Ethernet CBE20
Description
The CBE20 communication board must be inserted into the option slot of the Control Unit.
Four Ethernet interfaces are available on the module. Diagnosis of the function mode and
communication are possible via LEDs.
Interface overview
Figure 6-25 Communication Board Ethernet CBE20
MAC address
The MAC address of the Ethernet interfaces is indicated on the upper side of the CBE20.
The label is only visible when the module has not yet been installed.
Note
Please note the MAC address prior to installing the module so that it is available to you for
the subsequent commissioning.