Siemens SINAMICS G130 - Parameters, Faults and Alarms

Operation
6.10 Communication via EtherNet/IP
Inverter chassis units
Operating Instructions, 07/2016, A5E00331449A
297
6.10.6
Parameters, faults and alarms
Parameters
•
p0978
List of drive objects
•
p0922
IF1 PROFIdrive PZD telegram selection
•
p0999[0...99]
List of modified parameters 10
•
p8835
CBE20 firmware selection
•
p8842
COMM BOARD activate send configuration
•
p8940[0...239]
CBE2x
Name of Station
•
p8941[0...3]
CBE2x IP address
•
p8942[0...3]
CBE2x Default Gateway
•
p8943[0...3]
CBE2x Subnet Mask
•
p8944
CBE2x DHCP mode
•
p8945
CBE2x interfaces configuration
•
r8950[0...239]
CBE2x Name of Station actual
•
r8951[0...3]
CBE2x IP address act
ual
•
r8952[0...3]
CBE2x Default Gateway actual
•
r8954
CBE2x DHCP Mode actual
•
r8955[0...5]
CBE2x MAC address
Faults and alarms
•
F08501
PN/COMM BOARD: Setpoint timeout
•
A08526
PN/COMM BOARD: No cyclic connection
•
A50011
EtherNetIP/COMM BOARD: Configuration
error