Siemens SINAMICS G130 - TM31 Analog Outputs

Output terminals
8.2 TM31 analog outputs
Inverter chassis units
370 Operating Instructions, 07/2016, A5E00331449A
8.2
TM31 analog outputs
Description
The TM31 terminal block module features two analog outputs for outputting setpoints via
current or voltage signals.
Delivery condition:
● AO0: Actual speed value: 0 – 10 V
● AO1: Actual motor current: 0 – 10 V
Preconditions
● The Power Module, CU320-2, and TM31 have been correctly installed.
● The "TM31 terminals" or "PROFIdrive+TM31" default setting was chosen during
commissioning:
STARTER:
"TM31 terminals" or "PROFIdrive+TM31"
AOP30:
"2: TM31 terminals" or "4: PROFIdrive+TM31"
Signal flow diagram
Figure 8-1 Signal flow diagram: analog output 0
Function diagram
FP 1840,
FP 9572
TM31
- analog outputs (AO 0 ... AO 1)