Siemens SINAMICS G130 - Temperature Sensor Connection at a Sensor Module

Functions, monitoring, and protective functions
9.4 Monitoring and protective functions
Inverter chassis units
482 Operating Instructions, 07/2016, A5E00331449A
Temperature measurement via PT1000
The connection is made to user terminal block (TM31) at terminal X522:7/8. The measured
temperature is limited to between –99 °C up to +188.6 °C and is available for further
evaluation.
● Activating the motor temperature measurement via the external sensor: p0600 = 10
If the customer terminal block TM31 is present and on completion of commissioning, the
source for the external sensor is set to the customer terminal block (p0603 = {TM31}
r4105).
● Set the PT1000 temperature sensor type: p4100 = 6.
9.4.5.3
Temperature sensor connection at a Sensor Module
Temperature measurement via KTY
The device is connected to the appropriate terminals Temp- and Temp+ on the Sensor
Module in the forward direction of the diode (see corresponding section in chapter "Electrical
installation").
● Activate motor temperature measurement via encoder 1: p0600 = 1.
● Set the KTY temperature sensor type: p0601 = 2.
Temperature measurement via PTC
The device is connected to the appropriate terminals Temp- and Temp+ on the Sensor
Module (see corresponding section in chapter "Electrical installation"). The threshold for
changing over to an alarm or fault is 1650 Ω.
● Activate motor temperature measurement via encoder 1: p0600 = 1.
● Set the PTC temperature sensor type: p0601 = 1.
Temperature measurement via PT1000
The device is connected to the appropriate terminals Temp- and Temp+ on the Sensor
Module (see corresponding section in chapter "Electrical installation").
● Activate motor temperature measurement via encoder 1: p0600 = 1.
● Set the PTC temperature sensor type: p0601 = 6.