Siemens SINAMICS G180 - Residual Risks

List of messages
Display messages
05/2020, 4BS0576F-004
29
Msg-
Number
Display line 1
Display line 2
Text for event memory entry
Fault sup-
pression on
Description
3180 Fault P-Failure1/T =
Cabinet heater,
Motor heater,
MotorBearingTemp.,
MotorWindingTemp.,
Insulation Fault,
Fan external,
Cabinet fan,
external,
Set value < 4 mA,
Motor,
Transformer,
Temp.Motor,
Temp.Transform.,
I-asymm. motor,
Circuit breaker,
Fuse,
Fusing mains 1,
Fusing mains 2,
Undervoltage,
Overspeed,
Underspeed,
Motor stalled,
set value lost,
Setp/actv.dev,
Ball valve open,
Ball valve closed,
Control voltage,
Motor overpress.,
Switch high volt.,
Control transf.,
Ind. mains volt.,
Filter cabinet,
Aux. devices,
EarthCurr.,
prog. Text1, prog. Text2,
prog. Text3, prog. Text4,
prog. Text5, prog. Text6,
prog. Text7, prog. Text8,
prog. Text9, prog. Text10
Flt>CabinetHeater,
Flt>Motor heater,
Flt>M-BearingTemp,
Flt>M-WindingTemp,
Flt>InsulationFlt,
Flt>Fan external,
Flt>CabinetFan,
Flt>external,
Flt>SetValue <4mA,
Flt>Motor,
Flt>Transformer,
Flt>Motor-Temp.,
Flt>Transf-Temp.,
Flt>I-asymm.motor,
Flt>Circ. breaker,
Flt>Fuse,
Flt>Fusg. mains 1,
Flt>Fusg. mains 2,
Flt>Undervoltage,
Flt>Overspeed,
Flt>Underspeed,
Flt>motor stalled,
Flt>set val.lost,
Flt>Setp/actv.dev,
Flt>Ball valve op,
Flt>Ball valve cl,
Flt>Control volt.,
Flt>Motor overpr.,
Flt>Switch high V,
Flt>Contr transf.,
Flt>Ind. mains V,
Flt>Filter cab.,
Flt>Aux. devices,
Flt>EarthCurr.,
Flt>prog. Text1, Flt>prog. Text2,
Flt>prog. Text3, Flt>prog. Text4,
Flt>prog. Text5, Flt>prog. Text6,
Flt>prog. Text7, Flt>prog. Text8,
Flt>prog. Text9, Flt>prog. Text10
mean This concerns a user defined fault. It is parameterized acc. to
"P-FAILURES/P-Failure1/T = Text selection values". Here, the text of the
fault message can be out of a selection standard texts (see left-hand col-
umn) or a programmed text. Normally, this is not a fault that is to be looked
for in the inverter, it is to be found in the installation into which the inverter
is integrated.
3181 Fault P-failure 2/T= as no. 3180 as no. 3180 mean P-failure 2: as no. 3180
3182 Fault P-failure 3/T= as no. 3180 as no. 3180 mean P-failure 3: as no. 3180