List of messages
Display messages
05/2020, 4BS0576F-004
39
Text for event memory entry
3711 S1:1/4 off, S1:3 on? This message occurs only at IMS, when the switches are wrong, e.g. for
transfer a new language to the inverter. Please switch the switches correct.
3717 Initialization in process Initialization This message occurs only some seconds after switch on the control volt-
age. Is the message longer available, switch off/on the control voltage and
contact our service station.
3718 no inverter off ! Stop inverter with control release, e.g. for parameterization.
3719 Par.val.n.chngeable! This message occurs only via interface, when wrong parameters indicated.
Please use only correct parameters.
3720 Prim. initialization in process This message occurs only max. 60 seconds after primary initialization of
the inverter. Is the message longer available, start again the primary
initialization. Is the result the same, please contact our service station.
3721 new hardware S1:1 engaging - The inverter has found a new hardware (e.g. PCB Peripherals). This new
hardware must be logged in also in the EEPROM. That is only possible
when the parameterizing release is given.
Give a short parameterizing release. S1.1 shortly ON (10s), then OFF
again.
3723 Sub-index faulty! This message occurs only via interface, when wrong subindex of parame-
ters indicated. Please use only correct subindex.
3725 bootloader version! This message occurs only via interface, when wrong bootloader is used,
e.g. at upload of other inverter languages. Please contact our service
station.
To Next Page
Loading...
