Siemens SINAMICS G180 - Network Segmentation with SCALANCE S; Standard Mode Settings; Mode Std Siss

Operation
8.2 Standard mode settings
Installation and Operating Instructions SINAMICS G180
Operating Instructions, 02/2019, 4BS0751-007
135
8.1.15.5
Network segmentation with SCALANCE S
Siemens provides SCALANCE S security modules to meet network protection and network
segmentation requirements. These are modules support various security functions.
Further information on SIEMENS SCALANCE S can be found on the Internet
(https://w3.siemens.com/mcms/industrial-communication/en/ie/network-security/scalance-
s/Pages/Default.aspx).
Note
Data misuse
Long distances between the device to be protected and the upstream security modules
represent an invitation for data mi
suse.
Upstream security modules, such as SCALANCE
S, must be installed close to the device to
be protected in a locked control cabinet. This ensures that data cannot be manipulated here
without being observed.
8.2
Standard mode settings
8.2.1
Mode "std siss"
(D)
Dynamic: Pushbutton mode
(S)
Static: Switch mode
Figure 8-3 Assignment of the control cable terminals for "std siss" mode
Control behavior for "Local" (dynamic)
● Enter the command "Speed On" and "Speed Off" using the <On> and <Off> buttons on
the display.
● Make the setpoint value setting using the <down arrow> and <up arrow> buttons.
● Reset errors by pressing the buttons <S+I> simultaneously.