Siemens SINAMICS G180 - Operation According to NAMUR 2

Operation
8.3 NAMUR mode settings
Installation and Operating Instructions SINAMICS G180
140 Operating Instructions, 02/2019, 4BS0751-007
8.3.3
Operation according to "NAMUR 2"
(D)
Dynamic: Pushbutton mode
(S)
Static: Switch mode
Figure 8-8 Assignment of the control cable terminals for "NAMUR 2" mode
Operation different from "NAMUR 1"
The operation of the controller block for "Normal mode is dynamic.
● Start the drive with an NO (normally open) contact at -X2:10.
● You inhibit the converter with a normally closed contact at -X2:11.