Operation
8.4 Controlling the external connections of the inverter
Installation and Operating Instructions SINAMICS G180
152 Operating Instructions, 02/2019, 4BS0751-007
● Do not place any gearbox between encoder and motor.
Figure 8-18 Sincos encoder at -X25
● Use twisted pair cables for the same encoder tracks, e.g. A + / A -.
● Lay the cable shield on both sides at the encoder and inverter connector.
Connecting a TTL encoder to -X25
All encoder signals have a voltage level compliant with RS 422.
The encoder connection on the inverter side is a high density socket.
● Only use this encoder for field-oriented control with a speed accuracy < 1 %.
● Connect the encoder mechanically rigid to the motor.
● Do not place any gearbox between encoder and motor.
Figure 8-19 TTL encoder at -X25
To Next Page
Loading...
