Operation
8.8 Examples / Applications
Installation and Operating Instructions SINAMICS G180
Operating Instructions, 02/2019, 4BS0751-007
171
Control cable terminals "peripheral board 4"
PTC inputs, suitable for motors in the Ex-zone or Non-Ex-Zone
Remove the jumper if these control cable terminals are in use.
Remove the 100 Ω resistor if these control cable terminals are in use.
-X2:3: Four-way distribution terminal for 24 V, -X2:17, 18: Not assigned
In the case of an equipped peripheral board 3 / 4, the supply of the digital inputs -X2:8 … 16 is changed over. The
digital inputs are supplied from -X2:1/3 instead of -X2:51/55.
Figure 8-35 Control cable terminals for "peripheral board 4" application
Mode setting of the "Standard" application
The mode setting for the "Standard" application is "siss". Further information can be found in
section "Standard mode settings" (Page 135).
To Next Page
Loading...
