Siemens SINAMICS G180 - 4 Preparations for Use; Transporting Inverter

Installation and Operating Instructions SINAMICS G180
Operating Instructions, 02/2019, 4BS0751-007
71
Preparations for use
4
4.1
Transporting inverter
Procedure
● Persons operating cranes and fork-lift trucks must be appropriately qualified.
● Only use approved, undamaged and adequately dimensioned lifting equipment. Check
the equipment before using it.
● Observe the information in Chapter "Technical data for transport" (Page 194).
WARNING
Falling loads
If you are standing under a suspended load, then you are at risk of injury if the load falls off
the hoisting gear. This can result in death, serious injury or material damage.
Never stand in the area beneath a suspended load.
WARNING
Accidents during transport and when lifting
This can result in death, serious injury or material damage.
Carefully observe the transport instructions in this document as well as the generally valid
accident prevention regulations – especially BGI 556.
Always wear personnel protective gear such as protective footwear and gloves and a
helmet.
The converters are packaged by the manufacturer so that they can be transported on trucks.
NOTICE
Damage to converters during transportation
The converters can become damaged if they are incorrectly transported.
Observe the environmental conditions for transport in the technical data.