4. Ensure that the cell chassis mounting edges are sitting inside the edge of the groove rails, and
align the cell mounting holes (one on each side), with the corresponding rail receiver holes,
as shown in the gures labeled "...proper alignment of power cell mounting with receiving
holes".
Figure 10-18 40 A - 140 A - proper alignment of power cell mounting with receiving holes
Figure 10-19 200 A - 260 A, 4Q 120 A-160 A - proper alignment of power cell mounting with
receiving holes
Maintenance
10.7 Remove and Replace
Type 6SR5 Air-Cooled
Operating Instructions, AK, A5E39390112 87
To Next Page
Loading...
