Information for using the motors
7.5 Mounting
1PH7 induction motors (Machine tools)
Configuration Manual, (APH7W), 04/2009, 6SN1197-0AD72-0BP0
227
Flange mounting
For shaft heights 100 to 160 and with type of construction IM B35, it is only possible to flange
mount the motor using cylinder head screws.
For SH 180 to 225, flange mounting is only possible using studs and nuts. Clearance M1 for
threading the nut or screw between the motor flange and motor frame acc. to DIN 42948.
Table 7- 3 Flange mounting with threaded studs and nuts
Shaft height M1 [mm]
100 44
132 50
160 65
180 32
225 91
0
0RWRU
To Next Page
Loading...
