Siemens SINAMICS S Series - p0595 Selecting technological units; Select tech units; p0596 Reference quantity, technological units; Ref tech units

List of parameters
Parameters
1-207
© Siemens AG 2007 All Rights Reserved
SINAMICS S List Manual (LH1), 07/2007
Description: Selects the units for the parameters of the technology controller.
Values: 1: %
2: 1 referred, no dimensions
3: Bar
4: °C
5: Pa
6: ltr/s
7: m³/s
8: ltr/min
9: m³/min
10: ltr/h
11: m³/h
12: kg/s
13: kg/min
14: kg/h
15: t/min
16: t/h
17: N
18: kN
19: Nm
20: psi
21: °F
22: gallon/s
23: inch³/s
24: gallon/min
25: inch³/min
26: gallon/h
27: inch³/h
28: lb/s
29: lb/min
30: lb/h
31: lbf
32: lbf ft
Dependency: Only units of parameters with unit group 9_1 can be changed over using this parameter.
Refer to: p0596
Description: Sets the reference quantity for the technological units. When changing-over using changeover parameter 595 to
absolute units, all of the parameters involved refer to the reference quantity.
Dependency: Refer to: p0595
p0595 Selecting technological units / Select tech units
SERVO (Tech_ctrl),
VECTOR (Tech_ctrl)
Can be changed: C2(5) Calculated: - Access level: 1
Data type: Integer16 Dynamic index: - Func. diagram: -
P-Group: Applications Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
1 32 1
p0596 Reference quantity, technological units / Ref tech units
SERVO (Tech_ctrl),
VECTOR (Tech_ctrl)
Can be changed: T Calculated: - Access level: 1
Data type: Floating Point Dynamic index: - Func. diagram: -
P-Group: - Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
0.01 340.28235E36 1.00