List of parameters
Parameters
1-209
© Siemens AG 2007 All Rights Reserved
SINAMICS S List Manual (LH1), 07/2007
Description: Sets the sensor type for the temperature measurement at input X21 (booksize) or X41 (chassis).
The measured value is displayed in r0035.
Values: 0: No sensor available
1: PTC thermistor
2: KTY84
4: Bemetallic switch
Dependency: Refer to: r0035
Note: The measured value display depends on the selected sensor type.
Re p0601 = 1 (PTC):
Tripping resistance = 1650 Ohm (lower resistance --> r0035 = -50 °C, higher resistance --> r0035 = 250 °C).
Re p0601 = 2 (KTY84):
Displays the temperature in °C.
Re p0601 = 4 (bimetallic switch):
Tripping resistance = 100 Ohm (lower resistance --> r0035 = -50 °C, higher resistance --> r0035 = 250 °C).
When using the following components, a value of 4 is set as the factory setting and can no longer be changed:
- Basic Line Module (BLM) with internal Braking Module.
- Active Line Module (ALM) with line filter Active Interface Module (AIM, p0220[0] = 41 ... 45).
In these cases, in addition to the temperature display, the temperature is also monitored.
Description: Sets the sensor type for the motor temperature monitoring.
Values: 0: No sensor available
1: PTC thermistor
2: KTY84
3: KTY84 and PTC (only for temperature sensor via encoder)
4: Bemetallic switch
10: Evaluation via several temperature channels
Dependency: Refer to: r0458, p0600
Note: PTC thermistor (p0601 = 1): Tripping resistance = 1650 Ohm.
The temperature sensor for the temperature evaluation is set in p0600.
For p0600 = 10 (temperature sensor via a BICO interconnection), the setting in p0601 has no significance.
Re p0601 = 10:
When evaluating using SME120 or SME125 (r0458.8 = 1), 4 temperature channels are available ( parameterized
using p4600, p4601, p4602, p4603).
When evaluating using CU310 and CUA32, 2 temperature channels are available (encoder interface, parameteriza-
tion via p4600 / terminal strip, parameterization via p4601).
p0601 Temperature sensor, sensor type / Temp_sens type
A_INF, B_INF,
S_INF
Can be changed: C2(3), U, T Calculated: - Access level: 2
Data type: Integer16 Dynamic index: - Func. diagram: -
P-Group: Motor Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
0 4 0
p0601[0...n] Motor temperature sensor type / Mot temp_sensortyp
SERVO, VECTOR Can be changed: C2(3), U, T Calculated: - Access level: 2
Data type: Integer16 Dynamic index: MDS, p0130 Func. diagram: 8016
P-Group: Motor Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
0 10 2
To Next Page
Loading...
