Siemens SINAMICS S Series - p1291[0...n] Vdc controller integral time (V;f); Vdc_ctrl Tn; p1292[0...n] Vdc controller rate time (V;f); Vdc_ctrl t_rate; p1293[0...n] Vdc controller output limit (V;f); Vdc_ctrl outp_lim; p1294 Vdc_max controller automatic detection ON signal level (V;f); Vdc_max SenseOnLev

List of parameters
Parameters
1-367
© Siemens AG 2007 All Rights Reserved
SINAMICS S List Manual (LH1), 07/2007
Description: Sets the integral time for the Vdc controller (DC link voltage controller).
Description: Sets the rate time constant for the Vdc controller (DC link voltage controller).
Description: Sets the output limit for the Vdc controller (DC link voltage controller).
Description: Activates/de-activates the automatic sensing of the switch-in level for the Vdc_max controller.
Values: 0: Automatic detection disabled
1: Automatic detection enabled
Description: Sets the time threshold for the Vdc_min controller (kinetic buffering). If this value is exceeded a fault is output; the
required response can be parameterized .
Prerequisite: p1296 = 1.
p1291[0...n] Vdc controller integral time (V/f) / Vdc_ctrl Tn
VECTOR Can be changed: U, T Calculated: - Access level: 3
Data type: Floating Point Dynamic index: DDS, p0180 Func. diagram: 6320
P-Group: Functions Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
0 [ms] 10000 [ms] 40 [ms]
p1292[0...n] Vdc controller rate time (V/f) / Vdc_ctrl t_rate
VECTOR Can be changed: U, T Calculated: CALC_MOD_CON Access level: 3
Data type: Floating Point Dynamic index: DDS, p0180 Func. diagram: 6320
P-Group: Functions Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
0 [ms] 1000 [ms] 10 [ms]
p1293[0...n] Vdc controller output limit (V/f) / Vdc_ctrl outp_lim
VECTOR Can be changed: U, T Calculated: CALC_MOD_CON Access level: 3
Data type: Floating Point Dynamic index: DDS, p0180 Func. diagram: 6320
P-Group: Functions Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
0.0 [Hz] 600.0 [Hz] 10.0 [Hz]
p1294 Vdc_max controller automatic detection ON signal level (V/f) / Vdc_max SenseOnLev
VECTOR Can be changed: U, T Calculated: - Access level: 3
Data type: Integer16 Dynamic index: - Func. diagram: -
P-Group: Functions Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
0 1 1
p1295[0...n] Vdc_min controller time threshold (V/f) / Vdc_min t_thresh
VECTOR Can be changed: U, T Calculated: - Access level: 3
Data type: Floating Point Dynamic index: DDS, p0180 Func. diagram: -
P-Group: Functions Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
0.000 [s] 10000.000 [s] 0.000 [s]