Siemens SINAMICS S Series - r4250 TM17 set;reset time digital output 0; TM17 t_set DO 0; r4250 TM15 set;reset time digital output 0; TM15 t_set DO 0; r4251 TM17 set;reset time digital output 1; TM17 t_set DO 1; r4251 TM15 set;reset time digital output 1; TM15 t_set DO 1

List of parameters
Parameters
1-831
© Siemens AG 2007 All Rights Reserved
SINAMICS S List Manual (LH1), 07/2007
Description: Displays the time to set and reset for digital output 0 of terminal module 17 (TM17).
The two times are specified as 16 bit values with a resolution of 0.25 µs.
Note: DO: Digital Output
Description: Displays the time to set and reset for digital output 0 of terminal module 15 (TM15).
The two times are specified as 8 bit values with a resolution of 64 µs.
Note: DO: Digital Output
Description: Displays the time to set and reset for digital output 1 of terminal module 17 (TM17).
The two times are specified as 16 bit values with a resolution of 0.25 µs.
Note: DO: Digital Output
Description: Displays the time to set and reset for digital output 1 of terminal module 15 (TM15).
The two times are specified as 8 bit values with a resolution of 64 µs.
Note: DO: Digital Output
r4250 TM17 set/reset time digital output 0 / TM17 t_set DO 0
TM17 Can be changed: - Calculated: - Access level: 3
Data type: Unsigned32 Dynamic index: - Func. diagram: -
P-Group: Commands Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
- - -
r4250 TM15 set/reset time digital output 0 / TM15 t_set DO 0
TM15 Can be changed: - Calculated: - Access level: 3
Data type: Unsigned16 Dynamic index: - Func. diagram: -
P-Group: Commands Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
- - -
r4251 TM17 set/reset time digital output 1 / TM17 t_set DO 1
TM17 Can be changed: - Calculated: - Access level: 3
Data type: Unsigned32 Dynamic index: - Func. diagram: -
P-Group: Commands Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
- - -
r4251 TM15 set/reset time digital output 1 / TM15 t_set DO 1
TM15 Can be changed: - Calculated: - Access level: 3
Data type: Unsigned16 Dynamic index: - Func. diagram: -
P-Group: Commands Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
- - -