Siemens SINAMICS S120 - Page 678

Cabinet design and EMC Booksize
12.4 Arrangement of components and equipment
Booksize Power Units
678 Manual, (GH2), 07/2016, 6SL3097-4AC00-0BP8
Table 12- 3 Comparison of the connection versions
Var.
Module width
[mm]
Installa-
tion
Current-
carrying
capacity of
the
DC-link bus-
bar [A]
DC-link
adapter
6SL3162-...
DC-link
busbar
Fastening of the
DC-link adapter
to two DC-link
busbars
Screws
Washers
1
50 … 100
Right
≤ 100
2BM01-0AA0
Standard
2 screws
M4x20
No
2 50 … 100 Right ≤ 150
2BM10-0AA0
Reinforced
2 screws M4x20 No
3
50 … 100
Left
≤ 100
2BM01-0AA0
Standard
2 screws
M4x16
No
4
150
Right
≤ 150
2BM01-0AA0
Standard
2 screws
M4x20
No
5
150 … 300
Left
≤ 150
2BM01-0AA0
Standard
2 screws
M4x20
Yes
6
200 … 300
Right
≤ 200
2BM01-0AA0
Standard
4 screws
M4x20
No
Connections as cross-sectional drawings (view from below)
Note
The different connection versions of the DC
-link adapter are shown in the following cross-
sec
tional drawings. Special features are highlighted in bold in the table above.
Variant 1: Module width 50-100 mm, connected to the drive line-up from the right, standard DC-link
busbar
①
DC-link adapter 6SL3162-2BM01-0AA0 (4 hole)
②
Standard DC-link busbar (4 mm)
③
Connecting the DC-link adapter to the module using 2 M4x20 screws
④
Connecting the DC-link busbar to the module using 2 M4x16 screws
⑤
DC-link bridge
Figure 12-6 Variant 1 (representation from below)