Siemens SINAMICS S150 - 6.3 Basic information about the drive system

Operation
6.3 Basic information about the drive system
Drive converter cabinet units
Operating Instructions, 07/07, A5E00288214A
173
6.3 Basic information about the drive system
6.3.1 Parameters
Overview
The drive is adapted to the relevant drive task by means of parameters. Each parameter is
identified by a unique parameter number and by specific attributes (e.g. read, write, BICO
attribute, group attribute, and so on).
The parameters can be accessed via the following means:
● PC with the "STARTER" commissioning tool via PROFIBUS
● The user-friendly AOP30 Operator Panel
Parameter types
The following adjustable and visualization parameters are available:
● Adjustable parameters (write/read)
These parameters have a direct impact on the behavior of a function.
Example: Ramp-up and ramp-down time of a ramp-function generator
● Visualization parameters (read-only)
These parameters are used to display internal variables.
Example: current motor current
3DUDPHWHUV
UHDGU ZULWHUHDGS
%,&2RXWSXW 1RUPDOUHDG
SDUDPHWHUV
%,&2LQSXW 1RUPDO
UHDGZULWHSDUDPHWHUV
Figure 6-1 Parameter types
All these drive parameters can be read and changed via PROFIBUS using the mechanisms
defined in the PROFIdrive profile.