Siemens SINAMICS S200 - Checklist Prior to Mounting; Safety Labels on the Motor

5.2.2 Checklist prior to mounting
Description
The checklis
t below is a minimum benchmark and must be performed in any case. Further
checks before, during, and after the installation of the motor depend on the system-speci󹪝c
conditions and are the responsibility of the plant or system manufacturer.
Table 5-4 Checklist before installing
Check OK
General checks
Are the environmental conditions in the permissible range? 
Checks regarding the mechanical system
Is the motor free of visible damage? 
Have the mounting surfaces such as the 󹪞ang
e and shaft on the customer machine and on the
motor been cleaned?

Are the mounting surfaces free of corrosion? 
Do the mounting dimensions such as the shaft diameter, shaft length, and radial eccentricity
on t
he customer machine mee
t the speci󹪝cations?

5.2.3 Safety labels on the motor
Description
NOTICE
Damage to the encoder due to shocks
Shoc
ks at the mot
or shaft extension can cause an encoder damage.
• Do not exert any shock at the shaft extension.
In the delivery state, the following two warning labels are attached to the motor. In addition,
t
her
e ar
e t
hr
ee "hot surface" warning labels included in the scope of delivery. Before
mounting the motor, attach them to the motor surfaces and make sure that they are clearly
visible on all the four longitudinal sides of the motor.
"Hot surface" warning label
"No shocks at the shaft extension" warning label
Mounting
5.2Motor
SINAMICS S200 pulse train servo drive system with SIMOTICS S-1FL2
102 Operating Instructions, 11/2023, FW V6.3, A5E51646767B AA