Siemens SINAMICS S200 - Attaching Output Elements

Procedure
Proceed as follows to mount the feather key into the key slot:
1. Install the feature key ("①") to the key slot ("②") and make sure that the feather key and the
key slot are 󹪝tted closely. Siemens recommends that you place the V-type block ("③") under
the shaft extension for supporting.
2. Knock the feather key into the key slot by using a copper bar.



① Well‑lubricated feather key
② Key slot
③ V-type block
Figure5-4 Mounting the feather key
5.2.8 Attaching output elements
Ov
erview
Appropr
iate arrangement of the output elements reduces the bending torque load applied to
the shaft and the bearing.
Mounting
5.2Motor
SINAMICS S200 pulse train servo drive system with SIMOTICS S-1FL2
114 Operating Instructions, 11/2023, FW V6.3, A5E51646767B AA