Siemens SINAMICS S200 - Page 155

Connection example
• To use AI0 for the speed limit signal and AI1 for the torque limit signal, connect the terminals
as shown below:
&RQYHUWHU
$,



$,
$,
$,


$,
$,
$2B0
$2B0




• To use AI0 for the speed setpoint signal and AI1 for the torque limit signal, connect the
terminals as shown below:
&RQYHUWHU
$,



$,
$,
$,


$,
$,
9
9
9
9
$2B0




• To use AI0 for the speed limit signal and AI1 for the torque setpoint signal, connect the
terminals as shown below:
&RQYHUWHU
9
9
9
9
$,



$,
$,
$,


$,
$,
$2B0




More information
For more inf
ormation about the technical data of analog inputs, see Section "General technical
data (Page504)".
Connecting
6.8Connecting the inputs and outputs
SINAMICS S200 pulse train servo drive system with SIMOTICS S-1FL2
Operating Instructions, 11/2023, FW V6.3, A5E51646767B AA 153