Siemens SINAMICS S200 - Page 184

Display if changes have been made to the factory settings
The values entered are v
alid.
Display for checking of the modi󹪝ed values
At least one of the values needs to be modi󹪝ed.
Mandatory to comple
te quick setup
Figure7-4 Quick setup (example)
The most important properties of the converter are con󹪝gured in the quick se
tup.
Motor and encoder are directly detected during ramp-up. The data are accepted and shown
in steps "Motor" and "Encoder". These data are for information only and cannot be changed
during quick setup.
The converter creates a restore point when the quick setup is started. The converter saves
the changes after every commissioning step. The converter is reset to the restore point if the
quick setup is canceled.
The web server has a read-only mode for quick veri󹪝cation of the con󹪝guration data set.
Quick Setup Wizard
The Quick Setup Wizard of the web server guides you through the following quick setup
steps.
• "Drive information"
The step provides information about the converter, motor, encoder and motor holding brake
being used.
The following data can be changed:
– Drive name
A speci󹪝c drive name can be assigned.
• "Motor"
The data of the motor being used are displayed. It is not possible to con󹪝gure another motor.
The direction of rotation of the motor can be selected.
• "Encoder"
The data of the encoder being used are displayed. Con󹪝guration is not possible.
Commissioning (web server)
7.4Functions and menus
SINAMICS S200 pulse train servo drive system with SIMOTICS S-1FL2
182 Operating Instructions, 11/2023, FW V6.3, A5E51646767B AA