Siemens SINAMICS S200 - Page 204

Description of function
Figure7-14 Backup and restore
The following functions are available to back up and restore data and settings:
• Save driv
e data to backup 󹪝le
Back up the settings to a 󹪝le after commissioning.
The drive data are encrypted in the backup 󹪝le if function "Drive data encryption" is activated
in the Security Wizard.
• Restore drive data from backup 󹪝le
When replacing a device or for series commissioning, load the backed-up parameter settings
to the converter.
To restore drive data from an encrypted backup 󹪝le, the previously de󹪝ned password for
function "Drive data encryption" will be requested. For more details, see Section "Restoring
data from an encrypted backup data (Page206)".
• Restore factory settings
The user-speci󹪝c parameterization of the converter is deleted.
The following settings are retained after you restore factory settings via the web server:
– Settings of the communication interfaces
– UMAC and security data
To restore all settings, an SD card is required. For more details, see section "Reset of all user-
de󹪝ned settings to the factory setting via an SD card (Page481)"
Commissioning (web server)
7.4Functions and menus
SINAMICS S200 pulse train servo drive system with SIMOTICS S-1FL2
202 Operating Instructions, 11/2023, FW V6.3, A5E51646767B AA