Siemens SINAMICS S200 - Page 319

Display Example Description Remarks
Axxxxx
Alarm code In the case of a single alarm
A.xxxxx.
Alarm code of the 󹪝rst alarm In the case of multiple alarms
Axxxxx. Alarm code In the case of multiple alarms
Cxxxxx Safety message code In the case of a single safety message
C.xxxxx. Safety message code of the 󹪝rst safe‐
ty mes
sage
In the case of multiple safety messages
Cxxxxx.
Safety message code In the case of multiple safety messages
S O󹪜
Operating display: servo-o󹪜 -
r xxx Actual speed (positive direction) -
r -xxx Actual speed (negative direction) -
T x.x
Actual torque (positive direction) -
T -x.x Actual torque (negative direction) -
P.xxxxx Actual position (positive direction) The digits are not fully displayed. Press the
DOWN button to scroll t
o the next page.
Px.xxxx
Actual position (positive direction) The remaining digits have been fully displayed.
P.-xxxx Actual position (negative direction) The digits are not fully displayed. Press the
DOWN button to scroll t
o the next page.
Px.xxxx
Actual position (negative direction) The remaining digits have been fully displayed.
DCxxx.x Actual DC link voltage -
E.xxxxx
Position following error (positive di‐
rection)
The digits are not fully displa
yed. Press the
DOWN button to scroll to the next page.
Ex.xxxx
Position following error (positive di‐
rection)
The remaining digits have been fully displayed.
E.-xxxx Position following error (negative di‐
rection)
The digits are not fully displa
yed. Press the
DOWN button to scroll to the next page.
Ex.xxxx
Position following error (negative di‐
r
ection)
The
r
emaining
digits
have been fully displayed.
Restart
Restart the converter -
P----- The parameter does not exist. The symbol "P" could be other parameter sym‐
bols, like "T", "E", etc.
System messages
11.1SDI Status
SINAMICS S200 pulse train servo drive system with SIMOTICS S-1FL2
Operating Instructions, 11/2023, FW V6.3, A5E51646767B AA 317