Siemens SINAMICS S200 - List of Fault Codes and Alarm Codes

Acknowledgment
A fault can only be acknowledg
ed if the cause has been resolved.
The acknowledgment speci󹪝es when the fault can be acknowledged.
An alarm is self-acknowledging.
Table 11-7 Acknowledging faults
Acknowledg‐
ment
Description
IMMEDIATELY Acknowledgment can be immediately realized after the cause has been resolved.
PULSE INHIBIT Once the cause has been resolved, the fault can only be acknowledged when the
pulses are inhibited (r0899.11 = 0).
POWER ON The fault can onl
y be acknowledged using POWER ON (the converter is switched-o󹪜/
switched-on).
NONE For alarms (type "A"), an ackno
wledgment is not required.
Cause
Describes the possible causes of the fault or alarm. Op
tionally, a message value, fault value
or alarm value can be additionally speci󹪝ed.
Remedy
Generally explains possible procedures to resolve the cause of this active fault or alarm.
11.3.5 List of fault codes and alarm codes
Product: SINAMICS S200, Version: 603021000, Language: eng
Objects: S200 Basic PTI, S200 PTI
F01000 Internal software error
Message class: Hardware/software error (1)
Message value: Module: %1, line: %2
Component: Control Unit (CU)
Response: OFF2
Acknowledgment: POWER ON
Cause: An internal software error has occurred.
F
ault value (r0949, interpre
t hexadecimal):
Only for internal Siemens troubleshooting.
Remedy: - Evaluate fault bu󹪜er (r0945).
- Carry out a POWER ON (switch-o󹪜/switch-on) f
or all components.
- If required, check the data on the non-volatile memory (e.g. memory card).
- Upgrade 󹪝rmware to later version.
- Contact Technical Support.
- Replace the converter.
F01001 FloatingPoint exception
Message class: Hardware/software error (1)
Message value: %1
System messages
11.3Faults and alarms
SINAMICS S200 pulse train servo drive system with SIMOTICS S-1FL2
328 Operating Instructions, 11/2023, FW V6.3, A5E51646767B AA