Siemens SINAMICS S200 - Page 530




O
O
① Motor
② Motor shaft
③ Dial gauge
Figure13-4 Checking the radial eccentricity
Table 13-24 Concentricity and axial eccentricity tolerance of the 󹪞ange surface to the shaf
t axis
(referring to the centering diameter of the mounting 󹪞ange)
Motor Standard (Normal class)
1FL2102 0.06mm
1FL2☐03
1FL2☐04
1FL2☐05
0.08mm

1FL2306
1FL2310
0.1mm






PP
PP
$%
A Check for concentricity ① Motor
B Check for axial eccentricity ② Motor shaft
  ③ Dial gauge
Figure13-5 Checking the concentricity and axial eccentricity
Technical data
13.2Technical data of the motor
SINAMICS S200 pulse train servo drive system with SIMOTICS S-1FL2
528 Operating Instructions, 11/2023, FW V6.3, A5E51646767B AA