Siemens SINAMICS S200 - Page 531

13.2.11 Axial and radial forces
13.2.11.1 Permissible axial for
ces
Technical data
Table 13-25 Permissible axial forces
Type Axial force, static
1)
F
A s
tat
/ N
1FL2102 50
1FL2☐03 98
1FL2104
1FL2204
100
1FL2☐05 120
1FL2304 140
1FL2306 245
1FL2310 590
1)
The speci󹪝ed axial forces
are determined by the spring loading and therefore also apply to motors with
holding brake.
Note
Applications with an angular
toothed pinion directly on the motor shaft are not permitted if the
permissible axial forces are exceeded.
13.2.11.2 Permissible radial forces
Description
As a r
esult of the bearing arrangement, the 1FL2 is designed for aligned forces. Forces such as
these occur for belt drives, for example.
All radial forces always refer to aligned forces.
NOTICE
Motor damage caused by circulating forces
Circulating forces can cause bearing motion, and therefore damage the motor.
• Avoid rotating forces.
Technical data
13.2Technical data of the motor
SINAMICS S200 pulse train servo drive system with SIMOTICS S-1FL2
Operating Instructions, 11/2023, FW V6.3, A5E51646767B AA 529