Siemens SINAMICS S200 - Page 532

5
[
)
F
R
Point of application of the radial force
x Distance between where the radial force is applied and the shaft shoulder in mm
Figure13-6 Point of application of radial forces F
R
at the shaft extension
The f
ollowing diagrams indicate the maximum permissible radial force for the corresponding
motor frame size. It depends on the f
orce application point and the average speed for a
nominal bearing service life (L10h) of 20000 h.











)51
[PP
Q UPLQ
Q UPLQ
Q UPLQ
Q UPLQ
Q UPLQ
Q UPLQ
)/)5
/K 
K
Figure13-7 Radial force diagram 1FL2102
Technical data
13.2Technical data of the motor
SINAMICS S200 pulse train servo drive system with SIMOTICS S-1FL2
530 Operating Instructions, 11/2023, FW V6.3, A5E51646767B AA