Siemens SINAMICS S200 - Page 587

A.3 Parameters
A.3.1 Explanation of the list of par
ameters
Overview
The representation of a parameter includes as a maximum the information listed below.
Depending on the speci󹪝c parameter, some of the listed information is not applicable.
The parameters are displayed according to the following example:
8QLW
)DFWRU\VHWWLQJ0D[0LQ
1DPHRIWKHJURXSV3DUDPHWHUJURXS
5HDG\IRURSHUDWLRQ&DQEHFKDQJHGLQWKHRSHUDWLQJVWDWH
5HDGSHUPLVVLRQ
:ULWHSHUPLVVLRQ
9LVLEOHLQ6WDQGDUGGLVSOD\'DWDW\SH,QWHJHU
3DUDPHWHUQDPH
6DIHW\UHODWHGQRWHFRUUHVSRQGLQJWRWKHZDUQLQJQRWHFRQFHSW'DQJHU&DXWLRQ
:DUQLQJ1RWLFH
6HHDOVR
6HHDOVR
'HSHQGHQF\
>@ 1DPHDQGPHDQLQJRILQGH[
>@ 1DPHDQGPHDQLQJRILQGH[,QGH[
%LWDUUD\%LW6LJQDOQDPHVLJQDOVLJQDO
7H[W
7H[W
1RWH
7H[W
5HFRPPHQGDWLRQ
1DPHRIYDOXH
1DPHRIYDOXH
<HV1R
1R<HV1DPHRIELW
1DPHRIELW
9DOXH
9DULDQW
7H[W
'HVFULSWLRQ
5HDGGULYHGDWDRUDFNQRZOHGJHPHVVDJHV
(GLWGHYLFHFRQILJXUDWLRQRUGULYHDSSOLFDWLRQV



S[[[U[[[
)[[[[[$[[[[[&[[[[[


U[[[[
Description of function
Parameter number
The parame
ter number is made up of a "p", "r" or "c", followed by several numbers and
optionally an index and bit array.
The parameter number has the following syntax: pxxxx[0...n], rxxxx[0...n], cxxxx[0...n],
pxxxx.0...15 or rxxxx.0...15, cxxxx.0...15, pxxxx[0...n].0...15 or rxxxx[0...n].0...15,
cxxxx[0...n].0...15.
Examples of representation in the parameter list:
• p... Adjustable parameters (read and write)
• r... Display parameters (read-only)
Appendix
A.3Parameters
SINAMICS S200 pulse train servo drive system with SIMOTICS S-1FL2
Operating Instructions, 11/2023, FW V6.3, A5E51646767B AA 585