Siemens SINAMICS S200 - Page 740

6. Assemble the shielding B.
DEFG
Make sure that the installed shielding B is level. If it tilts upward, adjust as follows.
7. Insert the connector into the cable crimp slot in the crimping tool and crimp the cable shield.
8. Install the housing.
DEF
GHI
0DNHVXUHWKDWWKHFRYHUV
ODWFKLQ
WRSODFH
A.4.1.3 Assembling the setpoint connector
Requirement
You ha
ve prepared appropriate tools, raw cables, and the Siemens 50-pin MDR connector.
Appendix
A.4Assembling cables
SINAMICS S200 pulse train servo drive system with SIMOTICS S-1FL2
738 Operating Instructions, 11/2023, FW V6.3, A5E51646767B AA