Siemens SINAMICS S200 - Page 746

5. Crimp the contacts onto the conductors. Make sure that the lance side of the contacts face
outwards.
/DQFH
PPPP
PPPP
PPPP
6. Slide the power and signal cables through the seal case and the housing.
Avoid deforming the cont
act tips. Siemens recommends that you protect the conductors
with a tape during the process.
D
E
7. Insert the power and brake contacts into the power unit case and adjust the conductors to
make sure that the cable does no
t rise up.
DEF
G
H
Appendix
A.4Assembling cables
SINAMICS S200 pulse train servo drive system with SIMOTICS S-1FL2
744 Operating Instructions, 11/2023, FW V6.3, A5E51646767B AA