8. Insert the signal contacts into the signal unit case and adjust the conductors to make sure
that the cable does not rise up.
9. Insert the signal and the power unit cases into the housing by pulling the cables back.
Make sure that the signal and t
he power unit cases are latched to the housing.
10.Insert the shield holding plate into the housing.
11.Assemble the housing and the seal case.
–
Hold t
he shield holding plat
e and slide t
he seal case t
o the housing.
– Tighten the M2 screws with a tightening torque of 0.18 Nm ± 0.01 Nm.
Appendix
A.4Assembling cables
SINAMICS S200 pulse train servo drive system with SIMOTICS S-1FL2
Operating Instructions, 11/2023, FW V6.3, A5E51646767B AA 745
To Next Page
Loading...
