Siemens SINAMICS S210 - 7 Diagnostics; Status Displays and Operating Elements on the Converter; Status Display Via Leds; OK Button

Diagnostics
7
7.1 Status displays and operating elements on the converter
The status of the converter is displayed via the three-digit display as well as by the "RDY" and
"COM" LEDs.
Status display via the three-digit display
Normally, the display is dark.
Alarms and faults are shown according to the message classes defined in PROFIdrive. If
PROFIdrive diagnostics is active, then they are simultaneously transferred to the control
system.
Detailed information about alarms and faults is provided by the Web server of the converter.
Diagnostics in the Web server (Page 150)
Status display via LEDs
The converter displays the current operating state via two LEDs.
● RDY: converter state
● COM: communication state
During ramp-up, the LEDs assume different states.
The converter is ready for operation when the "RDY" LED is permanently green.
The LEDs always operate independently of one another, except when updating the firmware.
OK button
You can acknowledge the faults whose cause has been corrected with the OK button.



Display and operating elements on the converter
① LED display
② Three-digit display
③ OK button
SINAMICS S210 servo drive system
Operating Instructions, 12/2017, A5E41702836B AA 165