6.8 Connecting the re-cooling unit to the drive
Connection cables for auxiliary power supplies and control signals are already connected to
the drive. The remaining unconnected conductors are labeled. Connect these conductors to
the corresponding terminals of the re-cooling unit.
Further details are contained in the circuit diagram of the drive and the re-cooling unit.
6.9 Interconnecting optional connections
Depending on the range of options installed, further connections have to be interconnected.
Detailed information about interconnecting these options with the interfaces is provided in the
circuit manual.
6.10 Fastening the cable ducts with cable ties
Fasten all cable ducts whose cover faces downward with cable ties. Wind the cable ties around
the entire cable duct. The cable ties must be located at the same positions as in the delivered
state.
Image 6-6 Fastening the cable ties
Electrical connection
6.10 Fastening the cable ducts with cable ties
SINAMICS SM120 6SL38855?B
Operating Instructions 12/2015 83
To Next Page
Loading...
