Commissioning
4.1 The built-in Basic Operator Panel (BOP)
SINAMICS V20 Inverter
24 Getting Started, 07/2012, A5E03728127
Starts the inverter
If the inverter is started in HAND / JOG mode, the inverter running icon (
) displays.
Note:
This button is inactive if the inverter is configured for control from terminals (P0700 = 2, P1000 = 2) and
is in AUTO mode.
Multi-function button
Short press ( < 2 s)
• Enters the parameter setting menu or moves to the next screen
• Restarts the digit by digit editing on the selected item
• If pressed twice in digit by digit editing, returns to the previous screen
without changing the item being edited
M
Long press ( > 2 s)
• Returns to the status screen
• Enters the setup menu
Short press ( < 2 s)
• Switches between status values
• Enters edit value mode or change to the next digit
• Clears faults
OK
(No icon)
(With hand icon)
(With flashing hand icon)
Auto mode
Hand mode
Jog mode
Note:
Jog mode is only available if the motor is stopped.
• When navigating a menu, it moves the selection up through the screens available.
• When editing a parameter value, it increases the displayed value.
• When the inverter is in RUN mode, it increases the speed.
• Long press (> 2 s) of the key quickly scrolls up through parameter numbers, indices, or values.
• When navigating a menu, it moves the selection down through the screens available.
• When editing a parameter value, it decreases the displayed value.
• When the inverter is in RUN mode, it decreases the speed.
• Long press (> 2 s) of the key quickly scrolls down through parameter numbers, indices, or values.
+
Reverses the direction of rotation of the motor. Pressing the two keys once activates reverse motor
rotation. Pressing the two keys once again deactivates reverse rotation of the motor. The reserve icon (
) on the display indicates that the output speed is opposite to the setpoint.
To Next Page
Loading...
