Siemens SINAMICS V20 Inverter - Viewing Inverter Status; Editing Parameters

Commissioning
4.1 The built-in Basic Operator Panel (BOP)
SINAMICS V20 Inverter
26 Getting Started, 07/2012, A5E03728127
4.1.3 Viewing inverter status
The display menu provides a basic monitoring view of some key parameters such as
frequency, voltage, current, and so on.
M
M
M
M
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
M
M
M
M
Display
Menu
Setup
Menu
Parameter
Menu
9DOXHIODVKHV
2XWSXW
IUHTXHQF\
6HWSRLQW
2XWSXW
YROWDJH
0RWRU
FXUUHQW
!V
!V
!V
V
V
V V
V
V
+]
9+]
9
$
9GF
4.1.4 Editing parameters
Normal editing of parameters
NOTICE
Pressing
or for longer than two seconds to quickly increase or decrease the
parameter numbers or indexes is only possible in the parameter menu.
This editing method is best suited when small changes are required to parameter numbers,
indexes, or values.
● To increase or decrease the parameter number, index, or value, press
or for less
than two seconds.
● To quickly increase or decrease the parameter number, index, or value, press
or
for longer than two seconds.
● To confirm the setting, press
OK
OK
.
● To cancel the setting, press
M
M
.