Options and spare parts
B.1 Options
SINAMICS V20 Inverter
254 Operating Instructions, 07/2012, A5E03728167
BOP INTERFACE
NOTICE
To clone saved parameter settings from one inverter to another, a Parameter Loader or
BOP Interface Module is required. For detailed information about clone steps with the
selected option, see the data transferring steps described in respective sections (Appendix
B.1.1 or B.1.2).
Outline dimensions (mm)
Transferring parameter sets
The steps to transfer parameter sets between the inverter and the MMC / SD card using the
BOP Interface Module are the same as those using the Parameter Loader.
See Section "
Parameter Loader (Page 247)" for detailed description of the MMC / SD card
and the data transferring steps.
NOTICE
During transfer of parameter sets to or from the MMC / SD card, communications between
the BOP and the inverter is temporarily suspended.
To Next Page
Loading...
