Siemens SINAUT ST7 - View of the TIM 4 from below

Installing and putting a TIM into operation
4.3 Design of the TIM 3 and TIM 4 modules
Station control system
System Manual, 07/2009, C79000-G8976-C178-07
155
4.3.7 View of the TIM 4 from below
5-MDFN;
&RPELQHG5656LQWHUIDFHIRU
FRQQHFWLQJDQH[WHUQDOPRGHPXVLQJ
DGDSWHUFDEOH1+$6WKLVVKLSV
ZLWKWKH7,057,05'
5HVHWEXWWRQ
7KLVFDQEHXVHGWRIRUFHWKH7,0WRDGHIDXOW
VWDUWXSLILWFDQQRORQJHUEHFRQWDFWHGIRU
VRPHUHDVRQ
,ID'&)UDGLRFORFNLVLQVWDOOHGLQWKH7,0
7,0['WKHUHLVDJROGFRORUHGFRQQHFWRU
KHUHIRUFRQQHFWLQJWKH'&)DGDSWHUFDEOH
1+$'WKLVVKLSVZLWKWKH7,0
)URQWSDQHOODEHOHG
6,1$8767
)URQWSDQHOODEHOHG7,0
Figure 4-24 View of the TIM from below
DCF77 adapter cable
An adapter cable is required to connect the integrated DCF77 radio clock to an indoor or
outdoor antenna. The cable has a BNC male connector to which the normal antenna cable
can be connected.
The adapter cable is supplied with every TIM module with an integrated DCF77 radio clock.
It can also be ordered as a spare part under the number listed in the following table.