Siemens SINAUT ST7 - Page 200

Installing and putting a SINAUT modem into operation
5.5 MD2 dedicated line modem
Station control system
200 System Manual, 07/2009, C79000-G8976-C178-07

    
2))
21
2))
21


        

&KDQQHOZLUH
ZLUHPRGH
7UDQVPLWOHYHOದG%
ZLUHPRGH
&KDQQHOZLUH
%DXGUDWH



&KDUDFWHUIRUPDW

2)) 2))
2)) 21



1RUPDO
0RGH
2)) 2)) 2)) 2))
$V\QFKURQRXVELWV
$V\QFKURQRXVELWV
2))
2))
2))
2))
2))
21
5HSHDWHU
2)) 2)) 21 2))
:LWK56
SRUW
2)) 2)) 21 21
7HVWI+FRQVWDQW
21 2)) 2)) 21
7HVWVHQG56
21 2)) 21 2))
7HVWVHQG
7HVWUHFHLYH
21 2)) 21 21
21 21 2)) 2))
7HVWI
EDXG
7HVWI /
21 21 2)) 21
21 21 21 2))
7HVWI
+
21 21 21 21
21 2))
 21 21
7UDQVPLWOHYHOG%
&RQWUROVLJQDO 576
6TXHOFK2))
QRWXVHG
6TXHOFK21
5HVHUYHG
5HVHW7HVWUHFHLYH
Figure 5-11 Possible settings with the DIL switches accessible from above
When the MD2 modem ships, all DIL switches are in the OFF position. This corresponds to
the following basic setting:
● Transmit level –6 dB
● 4-wire mode
● Channel 1 ON (fixed setting for 4-wire mode)
● Baud rate 1200 bps
● Normal operating mode
● Message consists of 11-bit asynchronous characters
● Control output switched with RTS (only relevant for wireless connection)
The following table contains more information on configuring these default settings
individually.