Introduction to the SINAUT ST7 system
1.3 SINAUT TIM communication modules
Station control system
28 System Manual, 07/2009, C79000-G8976-C178-07
● This means that these devices can handle SINAUT communication over up to two
SINAUT WAN networks.
● The two transmission paths can be different or identical. They can be operated
independently or form a redundant transmission path.
● When installed as a CP in an S7-300, the following communication is also possible:
– With the CPU
– over the MPI interface of this CPU with other CPUs and control center PCs (ST7cc,
ST7sc) connected over the MPI bus.
– with other TIMs in this rack
● Message memory for up to 10,000 data messages
The following figure shows one of the TIM 4 variants.
Figure 1-5 SINAUT TIM 4 communications module
To Next Page
Loading...
