EasyManua.ls Logo

Siemens SINAUT ST7 - Page 36

Siemens SINAUT ST7
292 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Introduction to the SINAUT ST7 system
1.4 The classic SINAUT ST7 modems
Station control system
36 System Manual, 07/2009, C79000-G8976-C178-07
MD3
Permitted ambient conditions
Operating temperature
Transport/storage temperature
Relative humidity
0 °C through +60 °C
-40 °C through +70 °C
Max. 95 % at +25 °C
Construction
Module format
Dimensions (W x H x D) in mm
Weight
Compact module for S7-300, double width
80 x 125 x 120
Approx. 300 g
Degree of protection IP 20
Transmission path Analog dial-up telephone network
Dedicated line, 2-wire twisted pair, without
loading coils
Available ITU transmission standards in the analog
telephone network
V.22 1200 bps, duplex
V.22bis 2400 bps, duplex
V.32bis 4800 bps, duplex
V.32bis 9600 bps, duplex
V.32bis 14,400 bps, duplex
V.34bis 19200 bps, duplex
V.34bis 33,600 bps, duplex
Error correction V.42 and MNP4
Data compression V.42bis and MNP5
Modem control
AT commands
V.25bis commands
Metering pulse filter can be adjusted to
12 kHz
16 kHz
Dialing mode
Tone dialing
Pulse dialing
Loop power section Exists, can be switched in or out
Loudspeaker Exists, can be switched on or off
Line adjustment
600 ohms
Zr (frequency-dependent)
Transmit level can be set to
-10 dB
-15 dB
Asynchronous character format 10 or 11 bits
Standard dedicated line profile
300 bps (direct)
1200 bps (direct)
2400 bps (direct)
9600 bps (direct)
19,200 bps (direct)
19200 bps (buffered)
33,600 bps (buffered)

Table of Contents

Other manuals for Siemens SINAUT ST7

Related product manuals