EasyManua.ls Logo

Siemens SINAUT ST7 - 2.2 Connecting an MD2 to DTE, LTOP and Dedicated Line

Siemens SINAUT ST7
292 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Introduction to the SINAUT ST7 system
1.5 Mobile wireless components
Station control system
40 System Manual, 07/2009, C79000-G8976-C178-07
Note
The MD720-3 modem is used not only in SINAUT ST7 but also in SINAUT MICRO SC. In
this case, S7-200 stations can transmit data over GPRS using the MD720-3.
Along with the Ethernet TIMs as of firmware version V2.0, the MD720-3 can also transmit
data via GPRS in SINAUT.
In a station, the MD720-3 can be connected to the RS-232 interface of a suitably equipped
TIM module:
When using CSD: All TIM 3V-IE and TIM 4 variants
When using GPRS: Connection to any Ethernet TIM
The cable for connecting the MD720-3 must be ordered separately with a TIM.
The MD720-3 can be installed on a 35 mm standard rail.
Figure 1-9 Modem MD720-3
The following figure shows further details of the modem module.

Table of Contents

Other manuals for Siemens SINAUT ST7

Related product manuals