Introduction to the SINAUT ST7 system
1.7 Radio clock components
Station control system
52 System Manual, 07/2009, C79000-G8976-C178-07
● Software for configuring the GPS receiver (for Windows 95/98, NT, 2000, ME and XP)
● PC adapter cable, length 1.5 m
● Documentation
Since the GPS antenna is an outdoor antenna, you should also install the available lightning
protection device.
Figure 1-17 The GPS receiver module (left) and the recommended lightning protection device for
outdoor antennas (right)
The following figure shows the interconnection of the various GPS components (the adapter
cable 6NH7700-0AD15 is supplied with each TIM with an integrated DCF77 radio clock
receiver).
If lightning protection 6NH9831-8LA is used, this should be installed whenever possible at
the entrance to the building. To connect the lightning protection to the adapter cable of the
TIM, use a separate antenna cable (BNC female connectors at both ends, similar to the
antenna cable supplied with the outdoor antenna). You can either assemble this cable
yourself or purchase it from a dealer, for example from Hopf Elektronik GmbH
(
www.hopf.com).
To Next Page
Loading...
