Siemens SINAUT ST7 - Page 83

Operating Modes and Character Recognition
6NH7811-0AA22 © Siemens AG 2002 All Rights Reserved
4-16 MD2 Modem (07/2002)
The following illustration shows the setting on the 10-pin DIL switch of the MD2 for
the "Test f
baud
" operating mode.
Fig. 4-11 DIL switch setting for the
"Test f
baud
" operating mode
Note
Test operating mode "Test f
baud
" is not suitable for measuring the level over the
dedicated line. Use operating mode "Test f
H constant
" for making exact
measurements of the level.
123 4
OFF
ON
5678 910