1:
G10 is executed with internal STOPRE
Bit14: 0:
ISO mode T: No alarm if a cutting edge has been programmed in the T command.
1:
ISO mode T: Alarm 14185 if a cutting edge has not been programmed in the T command.
Bit 15: 0:
ISO mode M: G51 Scale, the axial scale factors I, J, K work with 'pocket calculator
notation' as programmed.
1:
ISO mode M: G51 Scale, the axial scale factors I, J, K with 'pocket calculator
notation', are multiplied by the value in MD22910 $MC_WEIGHTING_FACTOR_FOR_SCALE.
Bit 16: 0:
In circular-path programming with radius R, there is no replacement of missing
geometry axes of the selected plane. This corresponds to the behavior in Siemens mode
1:
In circular-path programming with radius R, missing geometry axes of the selected
plane are supplemented by incremental distance 0
20750 ALLOW_G0_IN_G96 C09, C05 P2, V1
- G0 logic with G96, G961 BOOLEAN PowerOn
-
- - TRUE, TRUE, TRUE,
TRUE, TRUE, TRUE,
TRUE, TRUE...
0 - 1/1 M
Description: This machine data defines the speed regulation characteristic of the spindle in G0
blocks with constant cutting rate (G96, G961) selected .
1: In a G0 block, the spindle speed is kept constant at the last value of the
previous block that was unequal G0.
Prior to a subsequent block that does not contain G0, the spindle speed is increased
to a value that belongs to the transverse axis position of the subsequent block.
0: In a G0 block, the spindle speed changes against the transverse axis position.
20800 SPF_END_TO_VDI C04, C03 H2, K1
- End of subroutine to PLC BYTE PowerOn
-
- - 1, 1, 1, 1, 1, 1, 1, 1... - - 1/1 M
Description: Bit 0 = 1:
The M functions for subroutine end (M17 and/or M2/M30) are transferred to the PLC
interface.
Bit 0 = 0:
The M functions for subroutine end (M17 and/or M2/M30) are not transferred to the PLC
interface.
Note:
To prevent stopping in continuous-path mode, M17 must not be programmed alone in a
block.
Example of a subroutine: G64 F2000 G91 Y10 X10
X10 Z10 M17
Bit 1 = 0:
M01:
conditional program stop is always output to PLC, irrespective of whether the M01
signal is active or not.
Machine data
3.3 Channel-specific machine data
Parameter Manual
172 List Manual, 01/2017
To Next Page
Loading...
