Frames
6.4 Programmable rotation (ROT, AROT, RPL)
Fundamentals
Programming Manual, 10.2004 Edition, 6FC5 298-7AB00-0BP1
6-17
Example of multi-side machining
In this example, identical shapes on two perpendicular workpiece surfaces are machined by
using subprograms. The setup of the infeed direction, working plane and zero point in the
new coordinate system on the right-hand workpiece surface matches that of the top surface.
The conditions required for subprogram execution apply as before: Working plane G17,
coordinate plane X/Y, infeed direction Z.
=
=
;
;
<
<
*
*
N10 G17 G54 ;Working plane X/Y, workpiece zero
N20 L10 ;Subprogram call
N30 TRANS X100 Z-100 ;Absolute offset
=
;
<
=
;
<
N40 AROT Y90 ;Rotation of the coordinate system through Y
To Next Page
Loading...
